mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/herbert/cryptodev-2.6.git
synced 2026-04-19 12:03:56 -04:00
a7f5cf3801
pm_power_off is an implementation detail. Replace it with a more generic description of the driver's functionality. Cc: Rob Herring <robh+dt@kernel.org> Cc: Pawel Moll <pawel.moll@arm.com> Cc: Mark Rutland <mark.rutland@arm.com> Acked-by: Mark Rutland <mark.rutland@arm.com> Acked-by: Andrew Lunn <andrew@lunn.ch> Signed-off-by: Guenter Roeck <linux@roeck-us.net> Signed-off-by: Thierry Reding <treding@nvidia.com> Signed-off-by: Rob Herring <robh@kernel.org>
37 lines
1.5 KiB
Plaintext
37 lines
1.5 KiB
Plaintext
Driver a GPIO line that can be used to turn the power off.
|
|
|
|
The driver supports both level triggered and edge triggered power off.
|
|
At driver load time, the driver will request the given gpio line and
|
|
install a handler to power off the system. If the optional properties
|
|
'input' is not found, the GPIO line will be driven in the inactive
|
|
state. Otherwise its configured as an input.
|
|
|
|
When the power-off handler is called, the gpio is configured as an
|
|
output, and drive active, so triggering a level triggered power off
|
|
condition. This will also cause an inactive->active edge condition, so
|
|
triggering positive edge triggered power off. After a delay of 100ms,
|
|
the GPIO is set to inactive, thus causing an active->inactive edge,
|
|
triggering negative edge triggered power off. After another 100ms
|
|
delay the GPIO is driver active again. If the power is still on and
|
|
the CPU still running after a 3000ms delay, a WARN_ON(1) is emitted.
|
|
|
|
Required properties:
|
|
- compatible : should be "gpio-poweroff".
|
|
- gpios : The GPIO to set high/low, see "gpios property" in
|
|
Documentation/devicetree/bindings/gpio/gpio.txt. If the pin should be
|
|
low to power down the board set it to "Active Low", otherwise set
|
|
gpio to "Active High".
|
|
|
|
Optional properties:
|
|
- input : Initially configure the GPIO line as an input. Only reconfigure
|
|
it to an output when the power-off handler is called. If this optional
|
|
property is not specified, the GPIO is initialized as an output in its
|
|
inactive state.
|
|
|
|
Examples:
|
|
|
|
gpio-poweroff {
|
|
compatible = "gpio-poweroff";
|
|
gpios = <&gpio 4 0>;
|
|
};
|