Set the interrupt type to rising edge within the example block in order
to match the new driver.
The entry that got replaced was not in use by the original driver.
Signed-off-by: Petre Rodan <petre.rodan@subdimension.ro>
Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Assert CPOL for a high-idle clock signal and CPHA for sampling on the
trailing (rising) edge.
Quoting from the datasheet:
"During the transitions on CSB, SCK must be high. SDI and SDO are driven
at the falling edge of SCK and should be captured at the rising edge of
SCK."
The sensor does not function with the default SPI clock mode.
Fixes: 7dbd479425 ("dt-bindings:iio:accel:bosch,bma220 device tree binding documentation")
Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Signed-off-by: Petre Rodan <petre.rodan@subdimension.ro>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Instead of listing directly properties typical for SPI peripherals,
reference the spi-peripheral-props.yaml schema. This allows using all
properties typical for SPI-connected devices, even these which device
bindings author did not tried yet.
Remove the spi-* properties which now come via spi-peripheral-props.yaml
schema, except for the cases when device schema adds some constraints
like maximum frequency.
While changing additionalProperties->unevaluatedProperties, put it in
typical place, just before example DTS.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Link: https://lore.kernel.org/r/20220816124321.67817-3-krzysztof.kozlowski@linaro.org
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
